MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Setting "Start of Device Value"		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

KAZ MotorSports

2 Posts
Posted - 10/03/2006 :  17:34:14  Show Profile
Hello folks,

I am a car tuner here in Colorado Springs.

I am currently dropping in a SST27SF512 in the place of a 27C256 chip. The site I bought the chip from says that to use the 27SF512 in place of a 27C256 that I must adjust the 'Start of Device' value when programming for 27C256 original, set to 8000 hex.

How do I do this on a Dual Power Willem Universal EPROM Programmer with the latest software version?

I did see how to adjust the jumper blocks for the proper read/write and then to erase, but curious how to change the start of device if possible.

Thanks much in advance!
-Kenny
KAZ MotorSports
Reply #1

BlueSky

14 Posts
Posted - 10/03/2006 :  20:53:13  Show Profile
Start Offset:

58.03 KB
Go to Top of Page
Reply #2

KAZ MotorSports

2 Posts
Posted - 10/04/2006 :  06:55:50  Show Profile
BlueSky...if you are ever in Colorado Springs I owe you a beer/soda/water whatever your poison!

Thank you VERY much!
-Kenny
Go to Top of Page
Reply #3

84sslt1

USA
13 Posts
Posted - 05/01/2008 :  06:28:24  Show Profile
Hey fellas!! How do I tell what device I had originally? 93 lt1 z28 Thanks
Tim
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000