Anyone else having this problem? Will burn NM27C64's with no problem. Using latest software 3.27. Anyone have a work-around. Or know of different software that will work with this programmer?
youll see v3.28 has better menus for ee/proms still says 3.27 on there site ...though but the file is v3.28
and several changes perhaps a fix try it out
i had to completely remove the drivers and app to get it to run properly
see the other post i made and how i removed the driver efficently
i notice you can do a no chip simuburn with 3.28 it burns and varifys fine with no chip inserted didnt try a blank test ticked i think it must be an older usb driver in use issue with your install for sure if your already using 3.28
machine toshiba equium laptop usb only type p5b asus main machine thinking of adding dual lpt pci card both used for top and lpt via usb where i can
old p2 programming grumbling tank with xp sp3 for true serial and lpt
all machines bios set to enable bios plug and play aware o/s and lpt spollers services and drivers removed legacy detection enabled
TOP2049 Will Not Burn CAT28C64
Forum Locked
Posted - 05/11/2008 : 05:36:11
