MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 Can't program 16F628A		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

dburniston

2 Posts
Posted - 01/15/2008 :  18:51:35  Show Profile
I have the enhanced JDM programmer and I'm having trouble programming the 16F628A. I've successfully programmed a 16F877A and a 12F675, so I know the programmer is ok.

PicPgm finds the programmer and identifies the PIC as a 16F628A. When I try to program, it says it works, but verify fails. Reading the chip shows all 0's. I can erase and if reverts back to 3FF.

I've tried PicPgm, WinPic800 and IcProg with similar results.

Anyone have any suggestions?
Reply #1

ZLM

2945 Posts
Posted - 01/19/2008 :  01:11:02  Show Profile
Check the code protection bit. It seems that bit been enabled.
Go to Top of Page
Reply #2

dburniston

2 Posts
Posted - 01/24/2008 :  16:29:14  Show Profile
Thank you!

Yes, the code protect was set in the sample hex file I downloaded to test. The program I was using didn['t make it clear until I checked with another.

I turned off code protect and it is working fine now.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000