I seem to have a problem with this chip (12F675) the software cannot detect the chip. I placed the chip pin 1 on the Ziff pin 8 (pin 1 facing the Ziff handle) but still not detecting.
Also when I try to program a loaded HEX file I don't need to set the config bits am I right or not?
If so what box should I check for the config on TOPWIN software?
pin 24 25{bottom} are pins 4 and 5 on the pic pin 1 on the pic would be pin 21 on the zif
any chip with a pinsize goes from bottom up in top programmers unless otherwise stated
in the top folder there is a folder marked place in it is some bmp files for positioning of certain chips if it's not there mostly !!! its bottom up
but dont quote me there info is sketchy at best
a trick is if you plug it in a do a test usualy the software will show you red pins and green ones and a yellowed set the yellowed ones are the target pins
machine toshiba equium laptop usb only type p5b asus main machine thinking of adding dual lpt pci card both used for top and lpt via usb where i can
old p2 programming grumbling tank with xp sp3 for true serial and lpt
all machines bios set to enable bios plug and play aware o/s and lpt spollers services and drivers removed legacy detection enabled
PIC 12F675 and TOP2005
Forum Locked
Posted - 05/17/2008 : 03:52:51
