MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Reading 27128		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

ozzy25

3 Posts
Posted - 03/13/2006 :  16:56:56  Show Profile
I am having trouble reading a 27128 chip from a Nissan ECU. I have the Enhanced Willem programmer. Everytime I read the chip the data is different. Looking at certain parts of the data, some of it is correct or mostly correct and other times completely wrong. When I try to do the verify it always gives me an error quickly. I desoldered the chip out of the ECU as best I could, maybe this chip got damaged? Or am I doing something wrong? Thanks.
Reply #1

ZLM

2945 Posts
Posted - 03/13/2006 :  20:44:18  Show Profile
The Enhanced willem does not work for most of 27128.

see

http://www.mcumall.com/forum/topic.asp?TOPIC_ID=16
Go to Top of Page
Reply #2

ozzy25

3 Posts
Posted - 03/13/2006 :  21:31:10  Show Profile
I will mainly be flashing an AT29C256. I only need to read the 27128 chip once, is it at all possible?
Go to Top of Page
Reply #3

ZLM

2945 Posts
Posted - 03/14/2006 :  21:16:10  Show Profile
Yes, it is possible. I think you need to route the power source by a wire.
Edited by - ZLM on 03/14/2006 21:17:06
Go to Top of Page
Reply #4

ozzy25

3 Posts
Posted - 03/15/2006 :  09:08:52  Show Profile
Does anyone know what wires I need to cross to read this chip?
Go to Top of Page
Reply #5

ZLM

2945 Posts
Posted - 03/15/2006 :  21:39:19  Show Profile
The 27128 is a 28 pin DIP chip. The Vcc pin is on pin 28. So, cross the pin 28 and ZIF 32. see if this works.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.14 sec. Snitz Forums 2000