MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 TOP USB Programmer
 In circuit programming?		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

TheRain

5 Posts
Posted - 04/06/2006 :  00:10:35  Show Profile
Is it possible to, say, stick some wires into the TOP programmer and run them to my PIC in circuit and prgram it??
Reply #1

ZLM

2945 Posts
Posted - 04/06/2006 :  01:11:48  Show Profile
Theoretically yes. But no info on this.

But you need to make sure a few points before plug it in:

1. since the wires are directly linking the programmer and the target board, there are no isolation circuit between them. You need to make sure your target board is using 5V VCC.
2. make sure the target board's PIC chip's Vpp pin is able to handle 14V Vpp.
3. make sure the ground are well connected.
Edited by - ZLM on 04/06/2006 01:12:23
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000