MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Can't erase or write an AM29F200AB chip		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

gobble

5 Posts
Posted - 03/13/2010 :  12:11:52  Show Profile
I'm using a PSOP44 adapter for the AM29F200AB chip. I can read it but can't erase or write to the chip. I belive I have all the jumpers set correctly. Any ideas or hints?
Reply #1

ZLM

2945 Posts
Posted - 03/13/2010 :  21:43:00  Show Profile
The chip may be protected.
Go to Top of Page
Reply #2

gobble

5 Posts
Posted - 03/14/2010 :  06:23:06  Show Profile
It's a brand new blank chip. Is it possible that it could be protected?

This is the exact chip:
h**p://store.americanmicrosemiconductor.com/scriptm29f200ab-90si.html

I can erase and write a 93C46 chip no problem.
Go to Top of Page
Reply #3

ZLM

2945 Posts
Posted - 03/24/2010 :  20:50:51  Show Profile
Most likely the new chip not be protected.
If this happend on new chips, then check the adapter contact to programmer.

You can lock the adapter on ZIF and then push the adapter little bit in ZIF, this will help to reduce the contact problem.

You should be able to get the ID correctly.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000