MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 need immediatehelp		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

SpartanXx666xX

USA
5 Posts
Posted - 07/16/2010 :  20:49:56  Show Profile
hey guys,

i just received my prg-017 in the mail and i tried to program my 12f683 chips and it wont write.

I open the program and select the 12f683 on the right bottom corner and place the chip accordingly. and when i load the hex file and click on program---i get the messaeg "the programmer does not recognize (12f683) processor. Continue anyway? I click yes and then i get the error "Received data error Apply reset"

i just went back and checkd the hex. the error starts from the EEPROM Data. because the error says good at 0x2b06 and bad at 0x000---where the EEPROM Data starts..

plz help

please help

thank you
Edited by - SpartanXx666xX on 07/16/2010 21:15:03
Reply #1

ZLM

2945 Posts
Posted - 07/17/2010 :  08:24:46  Show Profile
If the programmer does not detect the chip, then there are must be someting wrong.

check if the on board 18 pin DIP controller not loose from socket.
Change a USB cable.
Try it on another computer.

If the problem same, then contact the support@mcumall.com for warranty.
Go to Top of Page
Reply #2

SpartanXx666xX

USA
5 Posts
Posted - 07/17/2010 :  09:10:50  Show Profile
is there a way to make sure the 18pin is connected properly through software maybe?

and i tried the steps you mentioned and I am trying it on my laptop Windows 7 right now and still same thing
McLovin
Go to Top of Page
Reply #3

ZLM

2945 Posts
Posted - 07/17/2010 :  22:28:47  Show Profile
Well, if the chip is very thing good, then the software should be able to talk to it with out any error message.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000