MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 error when programming AT29C256		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

drummerdude

5 Posts
Posted - 06/23/2007 :  11:45:51  Show Profile
whenevr I try to program my chip I get ERROR:WRITE SECTOR ZERO
Reply #1

ZLM

2945 Posts
Posted - 06/24/2007 :  00:03:20  Show Profile
Check jumper settings.
Go to Top of Page
Reply #2

drummerdude

5 Posts
Posted - 06/24/2007 :  10:10:46  Show Profile
what should they be set at, all the jumper that are shown in the softwar window (when AT29C256 is chosen) I have them set to that, but it doesn't show all the jumpers?
Go to Top of Page
Reply #3

ZLM

2945 Posts
Posted - 06/25/2007 :  08:19:54  Show Profile
See:
http://www.mcumall.com/forum/topic.asp?TOPIC_ID=97
Go to Top of Page
Reply #4

drummerdude

5 Posts
Posted - 06/25/2007 :  16:26:40  Show Profile
I had to change computers, but now when I burn the chip, and then read it, it is not what I burned on there.
Go to Top of Page
Reply #5

ZLM

2945 Posts
Posted - 06/25/2007 :  19:43:08  Show Profile
If the software verified OK, then it should be programmed correctly. Otherwise the verification will fail.
Go to Top of Page
Reply #6

drummerdude

5 Posts
Posted - 07/06/2007 :  20:07:00  Show Profile
when I try to verify it shows, error at 0X000000.....
Go to Top of Page
Reply #7

ZLM

2945 Posts
Posted - 07/07/2007 :  12:34:35  Show Profile
can you give a picture of your programmer with chip on it? so that I can take a close look.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000