MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 d2764a verifies but doesn't work		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

jtmckinn

USA
1 Posts
Posted - 02/15/2017 :  06:07:54  Show Profile  Reply with Quote
I'm helping a friend revive some brunswick boards. I read the d2764a from a working board and verified them to the saved bin. pulled some d2764a's from a different board, erased, wrote, and verified those. Even though they verified when I try to boot the board with these burned chips it doesn't work. with the original rom set the board still works correctly. Any ideas?
Edited by - jtmckinn on 02/15/2017 06:09:35
Reply #1

ZLM

2945 Posts
Posted - 02/19/2017 :  00:18:56  Show Profile  Reply with Quote
Make sure the original chip checksum is same as the copied chip.
Go to Top of Page
Reply #2

fusioncliffs

3 Posts
Posted - 11/21/2017 :  08:41:40  Show Profile  Reply with Quote
I had a recent issue with an Intel 2764A it would read only "FF" data and would not verify. After much trial and error I found out the Toshiba TMM2764A protocol works perfectly !
Go to Top of Page
Reply #3

anniel

2572 Posts
Posted - 11/21/2017 :  09:03:21  Show Profile  Reply with Quote
quote:
Originally posted by fusioncliffs

I had a recent issue with an Intel 2764A it would read only "FF" data and would not verify. After much trial and error I found out the Toshiba TMM2764A protocol works perfectly !


Thank you for the info fusioncliffs.
The only difference is WVCC="6.2V".
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.1 sec. Snitz Forums 2000