I have a tek 2430a scope and the batteries in the old chips are going. I have a pair of new maxims coming along with the zif sockets to replace them. what programmer do I need to copy the old program and burn it to the new chips?do I need the ezo or do I need the willem?
ds1230ab, this is a new laptop and has something quirky about it. it likes to make corrections on its own. the mouse pointer will split a word or number and put one before the other.on the other side if you leave it on a link or a page over something it will take off on its owm. chip is ds1230ab
ds1230ab, this is a new laptop and has something quirky about it. it likes to make corrections on its own. the mouse pointer will split a word or number and put one before the other.on the other side if you leave it on a link or a page over something it will take off on its owm. chip is ds1230ab
DS1230AB, that's what I figured unless new chips where around... GQ-4X is fine with those.
Don't leave your new laptop alone with those BIN files.
done, done, and done. worst part was taking the blooming thing apart and getting it back together again. I used a tl866 plus to lift and reprogram the new sram 2015 date code so if these make 30 yrs someone else will worry about it then. thanks for the help fellows.
dallas ds1320ab
Forum Locked
Posted - 04/08/2018 : 04:04:04
