MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 93C86WQ... which device should I use?

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
eliotroyano Posted - 01/21/2013 : 06:48:03
Friends, as the title says, I need to read/write a ST93C86WQ 16bits eeprom on board with a GQ-3X programmer and a Pomona clip, then my doubts are:
1.- which device should I use? the exact code is not available in the list?
2.- does I need to swap bites to have a good read or writing again?
Thanks in advance for your help.
Regards,
Eliot

PD: This should be the eeprom --> http://www.st.com/internet/com/TECHNICAL_RESOURCES/TECHNICAL_LITERATURE/DATASHEET/DM00043901.pdf

Image Insert:

15.41 KB
1   L A T E S T    R E P L I E S    (Newest First)
eliotroyano Posted - 01/21/2013 : 17:52:11
I have readed tthe 93C86WQ with a 93C86C-16bit device using the GQ-3X and I think that it dump should be ok. But why does it read with bytes swapped?

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000