MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 27C256 jumper setting on dual power		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

ZLM

2945 Posts
Posted - 02/10/2006 :  22:29:26  Show Profile
Edited by - ZLM on 02/10/2006 22:29:49
Reply #1

Batch

3 Posts
Posted - 05/31/2006 :  17:33:09  Show Profile
ok the dip settings in the instructions were different than what you have showing. also, on the yellow jumper settings in the diagram, my board has one more jumper connecting the bottom 2 that are vertical of each other. Do I need to set them up like this? All the settings in your diagram is how the board should be correct? Thanks
Go to Top of Page
Reply #2

ZLM

2945 Posts
Posted - 06/01/2006 :  16:06:54  Show Profile
All the jumper settings and DIP settings must be set same as above.
Your vertical jumper is for AT29C256. You have to remove it.
Edited by - ZLM on 06/01/2006 16:08:01
Go to Top of Page
Reply #3

tizo

Hungary
5 Posts
Posted - 09/05/2006 :  01:24:03  Show Profile

Hi!

excuse but i m very newbie :) i m not realy sure.

please correct that:





thank you



Why drink and drive, when you can smoke and fly :) ?
Go to Top of Page
Reply #4

ZLM

2945 Posts
Posted - 09/05/2006 :  10:40:44  Show Profile
The Enhanced willem does not have the jumper 2 and 3 in the software. Instead it uses the LEDs to indicate the current jumper setting.

#3 in your borad picture(J3) is the A18/Vpp jumper. It located just left side of DIP in the software picture.
Go to Top of Page
Reply #5

tizo

Hungary
5 Posts
Posted - 09/05/2006 :  12:24:49  Show Profile
thank you!

now i look better!

Just /maybe because my english is very bad :)/ i look two jumper on the picture /program/ 2 yellow and evry two in the left side :( wich is the j3?

thx

Why drink and drive, when you can smoke and fly :) ?
Go to Top of Page
Reply #6

ZLM

2945 Posts
Posted - 09/06/2006 :  11:30:02  Show Profile
J3 is the #3 on your hardware board picture.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.11 sec. Snitz Forums 2000