MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 plz refresh memory		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

werejag

USA
75 Posts
Posted - 01/07/2008 :  01:43:47  Show Profile  Reply with Quote
27c160 i had a special zif socket version of the 16bit adaptor made and got the gq-3x

what am i doing wrong???

do i need any jumpers etc?
Reply #1

werejag

USA
75 Posts
Posted - 01/08/2008 :  02:51:27  Show Profile  Reply with Quote
nobody?
Go to Top of Page
Reply #2

ZLM

2947 Posts
Posted - 01/08/2008 :  09:55:08  Show Profile  Reply with Quote
You need connect the three address jumper wires to the programmer: A19, A20, A21.
Go to Top of Page
Reply #3

werejag

USA
75 Posts
Posted - 01/08/2008 :  13:45:10  Show Profile  Reply with Quote
maybe these are bad
Go to Top of Page
Reply #4

werejag

USA
75 Posts
Posted - 01/13/2008 :  04:57:36  Show Profile  Reply with Quote
found my error a piece of solder landed on 1k x10 resistor array pins 2-3-4 i hope nothing got damaged
Go to Top of Page
Reply #5

ZLM

2947 Posts
Posted - 01/13/2008 :  09:20:56  Show Profile  Reply with Quote
This should not damage anything. It only causes wrong signals.
Go to Top of Page
Reply #6

werejag

USA
75 Posts
Posted - 01/13/2008 :  11:12:11  Show Profile  Reply with Quote
good

is there a test process to make sure this programmer works 100% so i can be reassured and confident in it
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000