| Author |
 Topic  |
|
|
Becoacamba
Venezuela
14 Posts |
 Posted - 01/26/2009 : 09:21:00
|
hi I have a GQ-4X PROGRAMER and I`m Try to read with a test clip a 24C02= B58258 eeprom and the programer just shows the progress bar and said (reading. .. 24C02. the eeprom is a immo of a E.C.U Bosh I try now with 2 E.C.U.
The LED vcc on the programmer is red at moment to read the eeprom when normally is green. Now I try to use alimentation and gives me the same problem. thank you hopefully can help. |
|
| Reply #1
ZLM
2947 Posts |
Posted - 01/26/2009 : 20:46:05
|
Are you doing in circuit programming?
It does not read? or read but gives wrong data?
Is your ECU powered up?
How many lines you connected to the chip? |
 |
|
| Reply #2
Becoacamba
Venezuela
14 Posts |
Posted - 01/27/2009 : 03:42:29
|
hi Sr.
Are you doing in circuit programming? yes
It does not read? or read but gives wrong data? not read just read 2 times but no more.
Is your ECU powered up? not is powered
How many lines you connected to the chip? I conect the 8 lines of the serial eeprom and I'm connected correctly..
Thx. |
|
|
| Reply #3
Becoacamba
Venezuela
14 Posts |
Posted - 01/27/2009 : 03:48:56
|
| and I read another eeprom 24C02 of withus cell and read very well. |
|
|
| Reply #4
ZLM
2947 Posts |
Posted - 01/27/2009 : 17:32:21
|
"not read "?? does the software freezed during the reading?
If this is true, then the chip in circuit may not be able to programmed in circuit. It needs to removed from the PCB. |
|
|
| Reply #5
stevocz
Slovakia
27 Posts |
Posted - 04/20/2013 : 11:14:40
|
hi.
i have same problem.
I try read chip B58253 it is 24c02 SOP, but in gq-4x doesnt work read this chip, i am try various combinations chips in menu, but doesnt work.
in gq-4x still read only FF in chip
in willem usb/lpt work ok |
gq-4x4, gq-4x, willem usb/lpt |
Edited by - stevocz on 04/20/2013 11:23:03 |
|
|
| Reply #6
ZLM
2947 Posts |
Posted - 04/24/2013 : 22:41:42
|
| Check the connection. |
|
|
| Reply #7
stevocz
Slovakia
27 Posts |
Posted - 04/25/2013 : 08:57:42
|
| connection was good. chip was soldered into dip reduction. |
gq-4x4, gq-4x, willem usb/lpt |
|
|
| Reply #8
ZLM
2947 Posts |
Posted - 04/27/2013 : 18:40:17
|
| If you programming the chip on the programmer, then the chip may be the problem. |
|
|
| Reply #9
stevocz
Slovakia
27 Posts |
Posted - 04/28/2013 : 12:15:48
|
| chip was ok. in old willem lpt work at first read |
gq-4x4, gq-4x, willem usb/lpt |
|
|
| |
Topic |
|
I Have problem reading Eeprom 24C02= B58258
