There is not a setting in the programmer for the AM29F080B-120EC chip. I tried all of the other 29f080 settings and nothing seemed to work. What line of code would I need to add for this? Also using it on the GQ-4X with the ADP-077 Adapter. Thanks
If your chip is TSOP40 chip, then check your chip position in TSOP48 ZIF. The chip should in upper part of the ZIP, the pin 1 should at the top left corner. The voltage jumper on 5V position.
the AM29F080B is a common chip and it should be supported without problem. The TSOP40 adapter is only remapping pins into DIP32. I fyou can confirm the problem is the software algorithm, then a test chip is needed to findout the problem.
IF you can not get the chip ID correctly, then I suspect all your chips.
The problem is, there is not an option for the chip in the programmer software. There is a generic am29f080, and a am29f080b*PSOP44. My chip is 40 pin, with B at the end.
AM29F080B-120EC Settings?
Posted - 05/30/2014 : 22:11:42
