MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 GQ-4X stopped working

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
roybridge Posted - 11/15/2016 : 12:14:06
I only tend to program ST M27C1000 EPROMs. All was working up until last week, but now, every time I try to program, it fails at 6%.

The EPROMs themselves are ok (I've blanked them, and programmed with a different programmer).

I can verify and blank check OK, but not programme.

Any ideas or suggestions?
3   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 12/03/2016 : 21:58:54
The programmer A13 pin damaged.
roybridge Posted - 11/27/2016 : 12:01:43
This is the exact same error I get with each M27C1000 device that I try to write with my GQ-4X.

The devices are OK as I can program them with my TL866A programmer.

Image Insert:

18280 bytes
ZLM Posted - 11/21/2016 : 14:25:29
what is your exact error message?

If there is no contacting problem involved, then the problem may come from the programmer hardware.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000