MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 Write ST95160		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Perryking

7 Posts
Posted - 12/17/2015 :  03:17:43  Show Profile  Reply with Quote
Hi, I have the new GQ4X and I can read ST95160 but not write. It fails and say Device not supported. So GQ4X can't write ST95160?
Reply #1

anniel

2572 Posts
Posted - 12/17/2015 :  03:36:56  Show Profile  Reply with Quote
Is it in-circuit?
Go to Top of Page
Reply #2

Perryking

7 Posts
Posted - 12/17/2015 :  03:50:43  Show Profile  Reply with Quote
Yes, in circuit. But I read/write this eeprom in other boar in circuit without problems. What can I do?

Verify Failed. Address=0x000000, Device=0x01, Buffer=0x00
Edited by - Perryking on 12/17/2015 03:52:32
Go to Top of Page
Reply #3

anniel

2572 Posts
Posted - 12/17/2015 :  04:31:21  Show Profile  Reply with Quote
Pin 3 is grounded?
Go to Top of Page
Reply #4

Perryking

7 Posts
Posted - 12/17/2015 :  07:41:58  Show Profile  Reply with Quote
I changed Pomona clip for a new 3M clip and it worked. Thanks.
Go to Top of Page
Reply #5

anniel

2572 Posts
Posted - 12/17/2015 :  07:45:37  Show Profile  Reply with Quote
Bad contact to pins is always a possibility
Go to Top of Page
Reply #6

ZLM

2945 Posts
Posted - 12/21/2015 :  12:05:35  Show Profile  Reply with Quote
The in-circuit programming need to power the board separately. The programmer only connect the GROUND and other signals.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.13 sec. Snitz Forums 2000