MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 GQ-4X stopped working		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

roybridge

2 Posts
Posted - 11/15/2016 :  12:14:06  Show Profile  Reply with Quote
I only tend to program ST M27C1000 EPROMs. All was working up until last week, but now, every time I try to program, it fails at 6%.

The EPROMs themselves are ok (I've blanked them, and programmed with a different programmer).

I can verify and blank check OK, but not programme.

Any ideas or suggestions?
Reply #1

ZLM

2945 Posts
Posted - 11/21/2016 :  14:25:29  Show Profile  Reply with Quote
what is your exact error message?

If there is no contacting problem involved, then the problem may come from the programmer hardware.
Go to Top of Page
Reply #2

roybridge

2 Posts
Posted - 11/27/2016 :  12:01:43  Show Profile  Reply with Quote
This is the exact same error I get with each M27C1000 device that I try to write with my GQ-4X.

The devices are OK as I can program them with my TL866A programmer.

Image Insert:

18280 bytes
Go to Top of Page
Reply #3

ZLM

2945 Posts
Posted - 12/03/2016 :  21:58:54  Show Profile  Reply with Quote
The programmer A13 pin damaged.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000