MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Hardware Error: Check power & connection		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

burn

1 Posts
Posted - 08/26/2005 :  12:30:29  Show Profile
Hey, so I just received my new willems dual power programmer the other day, and today I tried to use it. I plugged in the printer cable & the USB cable. I start up the willem eprom program. I am programming AT29C256's. I selected that, set the jumpers & dips accordingly. No chips are in the ZIF. When I go to Help / test hardware it comes back: hardware error: check power & connection. Both cables are plugged in. Anyone help?
Reply #1

mcumall

78 Posts
Posted - 08/28/2005 :  20:42:20  Show Profile
Check your connections and BIOS LPT port setting. Most likely your connection is not good. Try to unplug and plug for a few times to eliminate the contacting issue. Also, in BIOS LPT setting need to be EPP/ECP mode.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000