MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 willem 3.1 help		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

allnighta

2 Posts
Posted - 05/29/2009 :  22:10:02  Show Profile
first off a big hello to everyone and im glad i found a site related to the willem since willem.org is gone
ok i got a willem 3.1 with a tsop 48 and i was hoping to program a intel te28f160 chip, ive just downloaded 97ja version of the software
but i cannot get the chip to id, all i get is a (----)can anyonehelp with the set up of the jumpers and stuff please

thanxs in advance
Reply #1

ZLM

2945 Posts
Posted - 05/30/2009 :  07:15:02  Show Profile
First, you need a 16 bit TSOP48 adapter.

Then the adapter jumper you have set to 28FXXX position.

The address lines need to be connected between adapter and programmer A19,A20,A21.
Go to Top of Page
Reply #2

allnighta

2 Posts
Posted - 05/30/2009 :  09:57:52  Show Profile
cheers m8 one more quick question, with the adaptor in place which is pin 1? looking at the adaptor the lever arm is on my right to hold it into place
is pin 1 top or bottom?
thanxs again
Go to Top of Page
Reply #3

ZLM

2945 Posts
Posted - 05/30/2009 :  21:17:37  Show Profile
There are different adapter designs. But most of adapter pin 1 is top-right.

The ZIF pin 1 is near ZIF lever handle.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.11 sec. Snitz Forums 2000