| Author |
 Topic  |
|
|
crusader
6 Posts |
 Posted - 05/10/2009 : 08:14:03
|
Hi all,I bought a top 2049 for programming eprom and gal but, if i programming or erasing the palce16v8h-25 i have some problems, for example just select the chip gives me "no bit find file" and if I try to erase I answered "0000001000000010000000100000001000000010000000100000001000000010
0000001000000010000000100000001000000010000000100000001000000010
Error at: L0000
Blank Error at ...: 00000 (00) "
there is a solution to solve?
Thank you and hello |
|
| Reply #1
tinhead
Germany
10 Posts |
|
| Reply #2
crusader
6 Posts |
Posted - 06/07/2009 : 08:47:32
|
OK, I had seen that had come out a new version, I installed the new version, the v5.78, and finally I have the full support to palce16v8h, now the law and program well.
5.73 was the version that did not work well.
hello and thanks |
Edited by - crusader on 06/07/2009 08:50:19 |
 |
|
| Reply #3
simeon
United Kingdom
79 Posts |
Posted - 06/08/2009 : 14:15:57
|
use usb 1.1 12mbps or usb 1.1 by using usb 1.1 hub
between the programmer and pc etc
this way forces usb 480kbps port to only use 12mbps
as coms to top usb programmer |
machine toshiba equium laptop usb only type
p5b asus main machine
thinking of adding dual lpt pci card
both used for top and lpt via usb where i can
old p2 programming grumbling tank with xp sp3 for true serial and lpt
all machines bios set to enable bios plug and play aware o/s and lpt spollers services and drivers removed
legacy detection enabled |
|
|
| |
Topic |
|
Pal Problems
Forum Locked
