MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 help need 16f628a		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

pb0ahx

Netherlands
4 Posts
Posted - 12/02/2010 :  03:39:50  Show Profile
if i writing a program in to the chip
then willem tel me that i have a writing error on ID area
( error writing pic id area )
this is mij firt writing to a pic
wat do i rong
can some body help me
the programmer is brand new type pcb5.5c
the 2 cabels are connected
i am new
Reply #1

ZLM

2945 Posts
Posted - 12/02/2010 :  11:15:29  Show Profile
Make sure you have erased the chip before write.

The ID area includes the user ID and CFG bits. Most likely you do not need the user ID. So, check the chip if the CFG bits are correct, then you can ignore the error.
Go to Top of Page
Reply #2

pb0ahx

Netherlands
4 Posts
Posted - 12/03/2010 :  04:19:49  Show Profile
the chip is empty
if i do chek then he say divices is blank
put i my .hex in the chip then he say the error
but i think the dipswitsh 1-12 is not on the right position
all the 12 switches stay on off
i am new
Edited by - pb0ahx on 12/03/2010 04:42:27
Go to Top of Page
Reply #3

pb0ahx

Netherlands
4 Posts
Posted - 12/15/2010 :  13:41:26  Show Profile
I found the error
the software that i used was 5.5c en is not ok
now i using 4.5 and now he is ok
gl all from delft holland
i am new
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000