MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 PCB3b just quit working...		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

ManiN

1 Posts
Posted - 05/07/2011 :  10:35:12  Show Profile
Have what I think is a PCB3b that was working fine on epr097ja software. I burned a few chips, read a few etc. then the next time I pull it out it wont respond to the software. I noticed that when I plug the parallel cable in, the yellow vcc light no longer lights up like it did before. When I plug in the 12v supply, all the leds light up and the transistor next to the usb gets crazy hot. It got hot before in process of burning, but not just on standby. I think a component may have failed. Any others have this happen? I tried using different computer with a parallel to see if the vcc would come on, but nothing. Thanks for the insight!
Reply #1

ZLM

2945 Posts
Posted - 05/11/2011 :  00:03:04  Show Profile
Your programmer may have some problem. You need to do a selftesting.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000