MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 EasyPRO/SmartPRO USB Programmer
 EasyPRO90B can't program HN27128G		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

amisouli

Greece
1 Posts
Posted - 01/27/2009 :  02:24:45  Show Profile
Hi all,

I have the following problem:
1) I check that the device is blank and it is
2) I change the first couple of bytes on the editor
3) I click on program.
- when the EPROM Memory is ticked I get 'Program Error' flashing
in the status bar
- when I untick it then it does 0.296s and says Successful. BUT
when I verify it's clear that there has been no change in the chip.

Since I am a junior here, can you please give me the first push?

THanks a lot in advance

Regards
aris
Reply #1

ZLM

2945 Posts
Posted - 01/27/2009 :  14:09:06  Show Profile
The chip need to be erased before write any new data. Even one byte data changed, whole chip have to be erased under UV eraser.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.14 sec. Snitz Forums 2000