MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 Problem with USB-Pic programmer		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

kitt1977

Belgium
3 Posts
Posted - 02/14/2009 :  14:15:45  Show Profile

When load a hex file to program a PIC18F2550 is get following problem.

Image Insert:

78.71 KB

So i can't program the hex into the pic afther the error message the hex is not loaded ..

What could i do about it ?


Tom
Reply #1

ZLM

2945 Posts
Posted - 02/15/2009 :  00:16:10  Show Profile
can you sent me your hex file? your hex file may be corrupted.
Go to Top of Page
Reply #2

kitt1977

Belgium
3 Posts
Posted - 02/15/2009 :  01:13:14  Show Profile
it's not corrupt , if i load it with Winpic or PicPGM is' load without problems , problem is those programs don't work with the usb programmer .. i have to use USB PIC PROG ....

h**p://www.on4top.be/pic/Node.03.37.hex

R
tom
Go to Top of Page
Reply #3

ZLM

2945 Posts
Posted - 02/15/2009 :  16:24:17  Show Profile
The file fomat is incompatible on fuse section.

Use WinPIC800 read the file and then save as into second hex file. Use USB PIC Prog to open the second file.

Check all you fuse values are correct before write into the chip.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000