MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Hardware Error: Check Power & Connection		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

Ira Gilbert

3 Posts
Posted - 02/28/2006 :  06:46:39  Show Profile
I have encountered the problem "Hardware Error: Check power and connection" but on only one of two computers.

I have the software installed on both a Dell Desktop running Windows 2000 and an IBM Thinkpad T43 running Windows XP. Both have parallel ports and can I print from either without difficulty. I have had no trouble using the Enhanced/Dual power programmer from the desktop, but I always get the hardware error when I try to use the laptop. The same leds are brightly lit on, and I have tried both bi-directional and ECP settings in my BIOS. EPP does not seem to be available. I am not sure if the problem is a computer setting or XP related problem. Can anyone suggest a next step?
Reply #1

Ira Gilbert

3 Posts
Posted - 02/28/2006 :  12:18:40  Show Profile
It appears that all I had to do was to select parallel port LPT3!
Go to Top of Page
Reply #2

ZLM

2945 Posts
Posted - 03/01/2006 :  18:54:52  Show Profile
You can change the LPT3 to LPT1 in laptop's CMOS setting.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.1 sec. Snitz Forums 2000