MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Programming with GQ-4X		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

pinguy

USA
1 Posts
Posted - 02/14/2010 :  18:29:33  Show Profile
I just received my new programmer, and have burned a few chips. However, I often receive an error message "write failed at..."
Does this happen if the chip is not blank? Do I have to erase chips first?
I have successfully copied a program on to an ST M27C256, and then not been able to copy the same program to a different ST M27C256 chip.
Reply #1

ZLM

2945 Posts
Posted - 02/14/2010 :  21:21:56  Show Profile
The chip need to be erased before write any new data.

Do a blank check before write the data. This will tell you if the chip blank.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000