MCUmall EPROM BIOS Chip Burner Forum - Programming 27C322 and 27C160

Active Users: / Visits Today:
Highest Active Users:

MCUmall EPROM BIOS Chip Burner Forum

Username:	Password:
Save Password
Forgot your Password?

All Forums

MCUmall Forums

Using The Enhanced/Dual power Willem Programmer

Programming 27C322 and 27C160

Forum Locked

Printer Friendly

Author

Topic

ben1059

2 Posts

Posted - 08/13/2006 : 11:33:28

I just bought the dual power willem eprom programmer with the 16 bit adaptor. I didnt get the diy cable set but instead I got three jumper wires. I can't figure out how to program 27C322 and 27C160 eproms. There isn't anything in the instructions on how to do it nor is there anything in the software that helps.

Reply #1

ZLM

2945 Posts

Posted - 08/22/2006 : 11:39:50

The three jumper wires are for the address line A19,A20,A21. Just connect those address line from adapter's address pin header to main programmer's address pin header.

See: http://www.mcumall.com/forum/topic.asp?TOPIC_ID=106 for the main pin header on the programmer board.

The DIP switch and the jumper setting need to confirmed with software indication when you selected the chip type from the software.

Edited by - ZLM on 08/22/2006 11:40:46

Reply #2

Necrosaro420

109 Posts

Posted - 02/23/2008 : 20:23:01

Sorry to dig up an old topic, but I am having the same issue. I have a willem pcb3, and I bought an sivava adapter of ebay ( http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=370014757919&ssPageName=STRK:MEWN:IT&ih=024 )

I set the jumpers according to willems software, and I get errors as soon as I started programming every time =(

Reply #3

ZLM

2945 Posts

Posted - 02/25/2008 : 08:49:00

If programming fail on random location, the your PCB3B does not work well on M27C800, M27C160 and M27C322. This is common issue on all PCB3B.

Topic

Forum Locked

Printer Friendly

Jump To:

MCUmall EPROM BIOS Chip Burner Forum

Generated in 0.07 sec.

Snitz Forums 2000