MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 Unable to Program PIC With Enhanced JDM Programmer		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

Deac

3 Posts
Posted - 11/27/2006 :  22:59:39  Show Profile
I just received my enhanced JDM programmer and I'm trying to program a 16F84A and I receive the error message:

ERROR -> Writting address 0x000003
Written : 0x0070 Read : 0x0000

I'm using winpic800 ver. 3.59
RS-232 straight through cable
Jumper set for 18 pin
I've tried both internal and external (12 volts) Vp
I've verified proper placement of PIC
I selected JDM programmer within winpic 800
com 1 (I do see the red LED flash when it tries to program)

Green power LED is on and the red PRG LED flashes briefly before fault occurs. I've also tried to program a 16F677 and had a similar failure. Anyone have any suggestions on what I should try next? or do I have a bad programmer?
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000