MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 reading and save as problem?		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

analyzerrepair

USA
1 Posts
Posted - 10/23/2011 :  11:10:40  Show Profile
I havent seen this problem in the forum, maybe someone can help.

I have used a hexeditor to change a little code and saved it.

When ever I used the GQ USB programmer software to read it, and then just save it back to the drive, the code changes?? (wtf?)

Is this something to do with the checksum of the orignal file I changed, edited and then saved?

How can I get around this?

Any help on this matter would be greatly appreciated.

Regards,
Reply #1

ZLM

2945 Posts
Posted - 10/27/2011 :  19:35:49  Show Profile
The file you loaded into GQ software may not exactly same size as your chip selected. So, the GQ software adjusted the size of the file to match the chip. The data should be same and the check sume changed for the new saved file from GQ software.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000