| Author |
 Topic  |
|
|
scar
10 Posts |
 Posted - 01/04/2012 : 20:14:21
|
I am trying to burn a 27C010 32pin eprom, and in the program I keep on getting this
img404.imageshack.us/img404/647/willem.jpg
I have a 12v PSU connected and all that so it cant be the power, and I have the device securely connected, and the eprom is snug in the zif socket. The jumpers are set right and all that. I do not know what is wrong. |
Edited by - scar on 01/04/2012 20:15:21
|
|
| Reply #1
scar
10 Posts |
Posted - 01/05/2012 : 14:55:47
|
| I just noticed on the thing, ICSP is in red lettering and none of the other chips have that that I have checked. Am I missing something? |
 |
|
| Reply #2
ZLM
2945 Posts |
|
| Reply #3
scar
10 Posts |
Posted - 01/09/2012 : 14:05:11
|
| It still says "Check Power and Connection" |
|
|
| Reply #4
scar
10 Posts |
Posted - 01/09/2012 : 16:20:14
|
| The only light that wont power on on the burner is the VPP, the others light up and the power light is Orange. |
|
|
| Reply #5
ZLM
2945 Posts |
Posted - 01/22/2012 : 23:39:47
|
| check the confirm the driver is installed. The driver only works WinXP or earlier version windows. Also, check the data cable is a good and correct. |
|
|
| Reply #6
scar
10 Posts |
Posted - 01/23/2012 : 14:41:59
|
| I am running the driver in compatibility mode, on top of that I used it in Windows 7s XP mode thing, and got the same result. |
|
|
| Reply #7
ZLM
2945 Posts |
Posted - 02/03/2012 : 22:29:50
|
| The dual power willem drivewr only works on XP or earlier version windows. |
|
|
| Reply #8
scar
10 Posts |
Posted - 02/05/2012 : 10:24:11
|
| I have the hacked .dll to allow it to work on W7 64Bit. It starts up fine. I am going to do a test, I have a TSOP40 Adapter, and I will try and write a TSOP40 chip using the adapter. |
|
|
| Reply #9
scar
10 Posts |
Posted - 02/11/2012 : 11:17:42
|
| I have it installed in XPmode which is virtualized Windows XP and its still giving me guff. |
|
|
| Reply #10
scar
10 Posts |
Posted - 02/21/2012 : 14:19:20
|
I tracked down an old Toshiba laptop running Windows 98 and installed the software, the hardware checksout except for the VPP light. I try to burn a chip (27C010) and it gives me this error message
Error at 0x00000A Chip= 0x00 buffer 0xFF |
|
|
| Reply #11
scar
10 Posts |
Posted - 02/21/2012 : 14:35:26
|
| Ok, the Parallel port needed to be switched to EPP and it now writes chips. But I have normal eproms and it has no trouble writing to the same chip, I don't know if its burning right |
|
|
| |
Topic |
|
Cant Burn
Forum Locked
