MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Standard Willem Programmer Operation		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

Bostelaar

1 Posts
Posted - 01/07/2005 :  13:09:39  Show Profile
I have a new Willem Standard Programmer and everthing seems to work fine. However, after about a minute of no activity, both the red and green lights come on. When I do the Help-Hardware test, they are turned off. Then about a minute later, they come back on. Is this normal, or a potential problem?
Reply #1

usb

138 Posts
Posted - 01/08/2005 :  00:17:06  Show Profile
It seems your PC LPT port been "hacked" by some software. To confirm this, unplug the data cable from programmer, and use a multimeter to monitor voltage change the pin 1 of data cable connector. See if the pin 1 voltage is changed after a minute.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000