MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 newbie question		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

the_graze

Canada
4 Posts
Posted - 06/14/2014 :  18:07:10  Show Profile
i have the GQ_4X great programmer i have used it to read write eeproms but my question is i want to jtag a 9S12H microcontroller ic on board i do have a six pin flat pad on the board i can solder or connect to for the purpose of communication is the or will the GQ-4X capable of this and what adapter would i need to carry this task through? the six pin pad has, positive, negative, bdm, reset only four of the pins are used from the research i have done so far. this is of course automotive related question thank you for any help greatly accepted. I have uploaded the pin pads as seen here at the tip of the screwdriver.

Image Insert:

47.27 KB
Edited by - the_graze on 06/15/2014 04:57:06
Reply #1

ZLM

2945 Posts
Posted - 06/15/2014 :  23:29:06  Show Profile
Sorry. The GQ-4X JTAG does not support this chip.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000