MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Power adapter for Enhanced?		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

lewinskys

Canada
4 Posts
Posted - 02/10/2005 :  17:49:52  Show Profile
I read about the ENHANCED Willem not having enough current to program some EPROMs like 2716/2732... The USB port can only deliver so much. Is there a way to put in a wall adapter to give it a bit more current to get over this problem?
Reply #1

mcumall

78 Posts
Posted - 02/11/2005 :  14:03:48  Show Profile
I do not think use a DC adapter will simply gain the current.

You may need more changes on the board. Such as change the Vcc control transistor and resisters.

The low current is not because of the USB port. There are some design issue there since it is not focused on higher current devices.

Also, since there is no schematic available, you may need trace the circuit. To find the exact component you want to change.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000