| Author |
 Topic  |
|
|
Perryking
7 Posts |
 Posted - 12/17/2015 : 03:17:43
|
| Hi, I have the new GQ4X and I can read ST95160 but not write. It fails and say Device not supported. So GQ4X can't write ST95160? |
|
| Reply #1
anniel
2592 Posts |
Posted - 12/17/2015 : 03:36:56
|
| Is it in-circuit? |
 |
|
| Reply #2
Perryking
7 Posts |
Posted - 12/17/2015 : 03:50:43
|
Yes, in circuit. But I read/write this eeprom in other boar in circuit without problems. What can I do?
Verify Failed. Address=0x000000, Device=0x01, Buffer=0x00 |
Edited by - Perryking on 12/17/2015 03:52:32 |
|
|
| Reply #3
anniel
2592 Posts |
Posted - 12/17/2015 : 04:31:21
|
| Pin 3 is grounded? |
|
|
| Reply #4
Perryking
7 Posts |
Posted - 12/17/2015 : 07:41:58
|
| I changed Pomona clip for a new 3M clip and it worked. Thanks. |
|
|
| Reply #5
anniel
2592 Posts |
Posted - 12/17/2015 : 07:45:37
|
| Bad contact to pins is always a possibility |
|
|
| Reply #6
ZLM
2947 Posts |
Posted - 12/21/2015 : 12:05:35
|
The in-circuit programming need to power the board separately. The programmer only connect the GROUND and other signals.
|
|
|
| |
Topic |
|
Write ST95160
