MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 2732--to--29c256		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

zipfast

USA
1 Posts
Posted - 05/24/2005 :  19:39:37  Show Profile
I know that you have to put in an offset to get the info at the end
of the chip, but where do you type it in at? I have the dual power kit and program. On my old programmer I would
start the buffer at 000000
end ..the buffer at 000FFF and
start the chip ...at 007000
end ..the chip ...at 007FFF
Is this the same for the Willem Programmer? If so where do you enter it at? on the (Device) tab "size & checksum" and "shift& pattern adr" OR on the (TEST H/W) tab which has address out and data out???????
Is there a help index of info or a data sheet for these programmers?
Any help would be GLADLY accepted
Reply #1

usb

138 Posts
Posted - 05/27/2005 :  10:59:28  Show Profile
If you are writing into AT29C256, then you can not change the data offset in this software. That because AT29C256 writing is based on fixed size sector.
One way you may want to try is using a binary editor to open the AT29C256 .bin file, then paste the data in to the .bin file where you wanted. Then use the programmer's software to open it and write to AT29C256.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000