| Author |
 Topic  |
|
|
steve
Italy
5 Posts |
 Posted - 02/21/2007 : 15:46:10
|
hi,
help me,
I have a top2004 programmer and can't read D27011 eprom,
the program topwin display: problem pin contact of: 6,35,36.
But this pin no to exist! 27011 is 28 pin eprom,
in 40 pin socket of programmer, 1-6 35-40 is not conected.
Best regards |
Edited by - steve on 02/22/2007 05:53:14
|
|
| Reply #1
Mauro
Argentina
3 Posts |
Posted - 02/22/2007 : 08:17:24
|
try with 27513 or 27C513 eproms.
bye |
 |
|
| Reply #2
steve
Italy
5 Posts |
Posted - 02/22/2007 : 14:26:29
|
27513 type and 27011 eprom:
with read command all ok,
with program command, topwin display:
error!(file=00 chip=ff)
can you help to me
best regard |
Edited by - steve on 02/24/2007 15:04:56 |
|
|
| Reply #3
Mauro
Argentina
3 Posts |
Posted - 02/27/2007 : 08:11:50
|
These devices have a voltage different from writing that of reading, your problem can be the soft TOPWIN, that version you have? you can unload the last version of http://www.top2048.com/gb/soft.htm
Best Regard |
|
|
| Reply #4
steve
Italy
5 Posts |
Posted - 02/28/2007 : 15:49:25
|
ok,
i have topwin 2.32 version,
now dounload 2.35 version and try.
bye (ciao)
|
|
|
| Reply #5
steve
Italy
5 Posts |
Posted - 03/01/2007 : 13:58:16
|
I have try with last software version.
I can not write the 27011 eprom.
I try with 27011 and 27513 set.
In 27011 set, no read and no write
In 27513 set, the writing stop in first address of memory
Best Regard
|
|
|
| Reply #6
steve
Italy
5 Posts |
Posted - 03/03/2007 : 05:59:51
|
help.
Perhaps the tension for programming is'nt correct.
(With write command the software stop in first addres and display this error "file=00 chip=ff").
I ask, is possible to forced the programming voltage whit external tension without damage the top programmer?
The top2004 programmer factory have a consumer suport mailbox?
Best Regard
|
Edited by - steve on 03/03/2007 06:03:06 |
|
|
| |
Topic |
|
top2004 programmer, problem with 27011 eprom
Forum Locked
