| T O P I C R E V I E W |
| Necrosaro420 |
Posted - 03/03/2008 : 09:46:56
I just purchased the true USB today, and it is the first time I am using it. Every single time, It goes the entire burn process (27c020), and during verify, I get this error:
Device verify failed to address: 0x000370, device read 0xFF, buffer is 0xA0
Any idea what a solution is for this? Thanks! |
| 7 L A T E S T R E P L I E S (Newest First) |
| Necrosaro420 |
Posted - 03/07/2008 : 20:49:09
well after I burned and failed verified, I tested it on actual hardware that I put it into, and everything seems like it went good |
| Necrosaro420 |
Posted - 03/07/2008 : 18:04:52
was getting ready to say yes, but we just bought a house and I took the power adapter over there yesterday, and to much snow on the ground to drive out there and get it lol. So I can try that tommorow. I am going to try to wire this chip up anyways to see if it works properly (one that failed on verify) ill report back. Thanks! |
| ZLM |
Posted - 03/07/2008 : 11:28:09
Can you try program in on GQ-3X and verify it on PCB3?
This will narrow down the problem to read/verify only.
Thanks. |
| Necrosaro420 |
Posted - 03/06/2008 : 17:27:50
yep, ive tried 5 from 2 batches...they burned fine with my willem pcb3 |
| ZLM |
Posted - 03/06/2008 : 13:46:55
M27C2001 should fully compatible with 27C020.
Do you have second 27C020 to try?
I tested on my GQ-3X and no problem. |
| Necrosaro420 |
Posted - 03/05/2008 : 18:17:36
Seems like it is the TI TMS 27C020's. The M27C2001 programs fine, but the 020's seem to have issues. Blank checked. Pincontact is good. Random location, just seconds after it starts to verify.
Here is the message:
Device verify failed at address: 0x002010, device read 0x7E, buffer is 0x5E
Time:21:12:56
Writing
Elapsed time: 87.52 seconds.
Time:21:14:24
Device write completed. OK
Code Verifing
Device verify failed at address: 0x002010, device read 0x7E, buffer is 0x5E
Device verify failed.
Elapsed time: 173.80 seconds.
|
| ZLM |
Posted - 03/03/2008 : 10:42:45
Can you get the correct ID of the chip?
Did you do the blank check before write?
Is it random location?
Pin contacting not good? |
