| T O P I C R E V I E W |
| Hartlauer |
Posted - 10/08/2024 : 12:01:39
Helli
Can you help me please
The GQ4x4 won't let me read this module, the bar goes up to 100% but there is no data. When I verify, an error message appears. What am I doing wrong? It's a ST M28F102-120K1 PLCC44 |
| 7 L A T E S T R E P L I E S (Newest First) |
| anniel |
Posted - 10/10/2024 : 08:27:55
quote:
Originally posted by Hartlauer
Change pin 1-2 and 2-3 no funktion
Are you certain the chip is good with data present? |
| Hartlauer |
Posted - 10/09/2024 : 12:39:31
Change pin 1-2 and 2-3 no funktion |
| Hartlauer |
Posted - 10/09/2024 : 12:39:01
Yes of course |
| anniel |
Posted - 10/09/2024 : 12:29:14
quote:
Originally posted by Hartlauer
The Jumper j1 is plugged between 1 and 2 and J5 is plugged into the 3 pins on the right so to speak between pin 2 and 3
Did you try changing J5 position? |
| Hartlauer |
Posted - 10/09/2024 : 11:47:13
I have the jumper in other position tested
Dont funktion . No identification and read FF |
| Hartlauer |
Posted - 10/08/2024 : 21:26:32
The Jumper j1 is plugged between 1 and 2 and J5 is plugged into the 3 pins on the right so to speak between pin 2 and 3 |
| anniel |
Posted - 10/08/2024 : 13:17:37
quote:
Originally posted by Hartlauer
Helli
Can you help me please
The GQ4x4 won't let me read this module, the bar goes up to 100% but there is no data. When I verify, an error message appears. What am I doing wrong? It's a ST M28F102-120K1 PLCC44
What are your jumper settings? |
