I use this chip in my honda accord to run it. I have dual programmer also. I can write to the chip and it runs my car so I know its working fine. Then I read the chip and try to pull the data up and I get file cant open. The bin file is good going into chip and runs car. It does read the chip and finish. Using Willem 0.97ja software.
I get the error when I try to open the file in my tuning software.
The file is fine when I burn it, then I read it from chip and it does not open. So something has to be changing when I burn it, like maybe the header or something. Or maybe its a setting within my Willem Eprom software.
Here is one of the files that was created in Crome software. I use it and edit it in Crome. After I burned it then read it, it no longer works in Crome.
Steps: 1. goto www.crldomain.com\honda 2. save the 1.bin to local c:\ drive 3. run the 0.j7a software 4. select device SST27SF512 from the software 5. open the file "1.bin" form local c: drive
The software shows the 1.bin file loaded.
Then you can erase the chip and write the data into the chip.
I know you can load the bin file in Willem software and burn/write it to chip.
What Im saying is that the file was originally created in Crome and when I write it to chip, then read it from chip something changes b/c I cant load the file back into Crome if its read off of chip.
Reading chip SST27sf512
Forum Locked
Posted - 08/04/2007 : 09:56:43
