MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 no vpp for 27cxxx		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

va3nth

Canada
2 Posts
Posted - 12/01/2005 :  20:48:23  Show Profile
i no longer have a vpp when programming eproms. LPT pin 16 swings to 0-1.53v when programmer plugged in, 0-5 volts without. traced to pin 12 of ic beside green and red led. looks like this is a comparator as there is programming voltage present on pin4. what is the chip so i can try replacing it?

Christopher
Reply #1

ZLM

2945 Posts
Posted - 12/02/2005 :  11:48:36  Show Profile
I assume your programmer is Enhanced version.
The Vpp is controlled by LPT port pin 1. NOT the LPT port pin 16.

It seems your LPT port pin 1 has low current output than programmer needed. So, you do not need replace the chip, only the threshold resister R1. (change to 1K see if it is works)

Please see thread following thread for more info:

http://www.mcumall.com/forum/topic.asp?TOPIC_ID=93
Edited by - ZLM on 12/02/2005 11:57:16
Go to Top of Page
Reply #2

va3nth

Canada
2 Posts
Posted - 12/03/2005 :  17:02:25  Show Profile
Thanks! 1.2k resistor in parallel with existing 'r1' did the trick..

i just assumed that I blew something as it did function before.

Christopher
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000