MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 PRG-017 USB won't program EEPROM		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

ICSG

6 Posts
Posted - 06/28/2009 :  18:09:37  Show Profile
Using the PRG-017 USB PIC programmer, all works well unless there is EEPROM data in the HEX code. If I try to have it program the EEPROM as well as the flash program area, it comes up with an error similar to:

EPROM error at 0x0001
Good 0x68
Bad 0x29

This happens on every chip I have tried - various 12F629 and 16F629A.

Any thoughts?
Reply #1

ZLM

2945 Posts
Posted - 06/28/2009 :  18:42:27  Show Profile
what software version you are using?

Try to increase the programming delay time for this chip.

Open the "CHIPINFO.cid" file in the application directory and search the "12F629", increase the "ProgramDelay=" parameter.
Go to Top of Page
Reply #2

ICSG

6 Posts
Posted - 06/28/2009 :  23:53:55  Show Profile
Thank you! I will make the change and try it!

Would modifying this file work to add support for PIC's that aren't currently supported by the software? I have a couple of 18LF4682 that aren't supported.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000