MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 General Discuss
 Can read but not write with dual programmer		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

joncom

1 Posts
Posted - 11/12/2004 :  07:38:41  Show Profile
I try to burn a 2732A chip. I can read similar chips, I can verify that the new is blank, but I can't write to the chip. It says programming chip(the red status bar increases), but the chip is still blank. I have a 12 V power supply and have set all the jumpers according to the software(I think). I have tried another PC, but same problem. Any Ideas?
THanks

JOn
Reply #1

usb

138 Posts
Posted - 11/13/2004 :  23:22:23  Show Profile
Most likely your Vpp setting is not correct.
Also, the Vcc you need set to 6.2V.

Most of 2732 uses 25V Vpp, but some may use 21V or 12V. Confirm your chips Vpp from the datasheet.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000