| T O P I C R E V I E W |
| poppycomp |
Posted - 03/13/2009 : 22:52:12
I tried to write W25X32 and it did not work every time. Any suggestions?
|
| 12 L A T E S T R E P L I E S (Newest First) |
| poppycomp |
Posted - 03/27/2009 : 23:59:08
GQUSBprg 4.01 and GQ USB Driver 2.01
With new software and new drivers works ( speed "0" ).
|
| ZLM |
Posted - 03/19/2009 : 23:28:06
We will take look to this. |
| poppycomp |
Posted - 03/19/2009 : 05:07:22
the data on the chip cannot be erased regardless of the speed used ...
when the next version of software will be available? Also any other solution for this? |
| ZLM |
Posted - 03/18/2009 : 09:51:31
The chip must be erased before can be correctly programmed new data.
So, use the slow speed to repeat the erase untill it is erased.
Change to normal speed for writting. |
| poppycomp |
Posted - 03/16/2009 : 01:10:27
I've managed to write 5 chips (w2tx32) after several failed attempts; I could not find a solution to have successful flashing each time.
The bin file is written without errors, but at read on the chip its still the initial information before the write
the average flashing time is around 20 mins on max speed |
| ZLM |
Posted - 03/15/2009 : 23:03:32
It seems this chip is unable to be erased. It is possible that the chip is a bad chip. |
| poppycomp |
Posted - 03/15/2009 : 22:52:22
Yes,I tried to delete before write but information still remaining.
I managed to write 5 pieces but I have a lot of flash written.
Last ten attempts were failed.
Image Insert:
21.63Â KB |
| ZLM |
Posted - 03/15/2009 : 22:40:55
Did you erase the chip and do a blank check? |
| poppycomp |
Posted - 03/15/2009 : 12:19:17
This is the result after erase and write jobs.Is not a constant error.
Device ID (HEX) :EF3016 Winbond W25X32
Image Insert:
104.3Â KB
Image Insert:
102.8Â KB
Image Insert:
104.89Â KB
Image Insert:
100.06Â KB |
| ZLM |
Posted - 03/15/2009 : 08:55:07
Can you get the ID correctly?
What is the address on verify error?
Does it always fail on same address? |
| poppycomp |
Posted - 03/14/2009 : 15:05:33
Yes, is it on ZIF .Not error message on writing.Error message on verifying (when compare data ).Yes,I tried use slower speed.
Sorry,but I don’t speak english. |
| ZLM |
Posted - 03/14/2009 : 10:18:45
Please provide more details:
1. Is it on ZIF or in circuit programming?
2. What is the exact error message?
3. What means "not work every time"?
4. Did you try to use slower speed?
|
