| T O P I C R E V I E W |
| Charco |
Posted - 01/01/2012 : 13:46:54
Hi all! I write to this forum in Spain. I have a problem with my recent GQ-4X Willem Programmer. The problem is as follows.:
The system was running the factory software, version 6.00, and it worked correctly.
These days I updated the latest software from www.download.mcumall.com page, and I downloaded the version 6.14C. Since then, I can not start the program, ie the program opens, but it is blocked. I uninstalled the program, I have reinstalled the software first, and then I connected the programmer, but does not install the USB drivers. Someone could help me with this problem. Thanks in advance. Greetings and Happy New Year!!
|
| 3 L A T E S T R E P L I E S (Newest First) |
| Charco |
Posted - 01/27/2012 : 07:18:42
Good afternoon friends Oswaldo and ZLM! A few days ago I did not connect, and I have now read the messages you sent me ... I've tried everything, uninstalling everything, installing the software on another computer ... in 'End of all ... and it will not. I contacted the technical service Mcumall, and they told me that I have to send the programmer, since it is under warranty. However, the explanation I have given them, surely have a problem with these programmers GQ-4X, because I have asked nothing more. Well kids, and I'll comment as the story goes. Greetings and thank you very much!
|
| osvaldo |
Posted - 01/19/2012 : 19:28:11
paso a explicarle
1 desístala el programa de panel de controle
2 luego vas al c donde se instalo el programa y lo borra
3 una vez echo eso instala el nuevo soft y tiene que funcionar sin problema
|
| ZLM |
Posted - 01/03/2012 : 23:45:01
If your programmer works on Re6.00, then it should work on 6.14C. They are same on communication part.
You do not reinstall the driver.
|
|
|
