MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 GQ-4X not burning AT27C256R OTP		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Necrosaro420

109 Posts
Posted - 10/22/2013 :  12:27:25  Show Profile  Reply with Quote
They act like they are starting to burn, go to 1% and quit. But then I do a blank check, and they still show as blank?
Reply #1

Necrosaro420

109 Posts
Posted - 10/24/2013 :  20:12:48  Show Profile  Reply with Quote
Any ideas?
Go to Top of Page
Reply #2

ZLM

2945 Posts
Posted - 10/27/2013 :  11:27:50  Show Profile  Reply with Quote
Can you ID the chip? IF you can not ID the chip, then it maybe related to the pin contacting OR chip itself.
Go to Top of Page
Reply #3

Necrosaro420

109 Posts
Posted - 10/27/2013 :  13:01:13  Show Profile  Reply with Quote
Device ID: 1E8C, Atmel, Type: AT27C256R
Go to Top of Page
Reply #4

ZLM

2945 Posts
Posted - 11/06/2013 :  14:46:18  Show Profile  Reply with Quote
There are many other users used this programmer to program AT27C256R, and no problem reported. That means the software should OK.

Did you try differenr speed? The chip also can be programmed with regular standard 27C256 device type.
Go to Top of Page
Reply #5

briank9803

USA
11 Posts
Posted - 05/02/2014 :  14:52:16  Show Profile  Reply with Quote
How do you set speed with software 6.29 GQ-4X? I'm having a similar problem.
____________
Brian
Go to Top of Page
Reply #6

ZLM

2945 Posts
Posted - 05/05/2014 :  10:47:55  Show Profile  Reply with Quote
There is a speed setting area on the right software panel. From -2 to +2
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000