MCUmall EPROM BIOS Chip Burner Forum - 27c801 with Willem Enhanced USB

Active Users: / Visits Today:
Highest Active Users:

MCUmall EPROM BIOS Chip Burner Forum

Username:	Password:
Save Password
Forgot your Password?

All Forums

MCUmall Forums

Novice Place

27c801 with Willem Enhanced USB

Forum Locked

Printer Friendly

Author

Topic

chaoticjelly

4 Posts

Posted - 09/21/2005 : 19:36:51

I have the Willem Enhanced USB with some chip part numbers scratched off.

What im trying to do is program 27c801 EPROM.

I have everything connected correctly and a hardware test tests OK!

I have the chip in the socket, grooved edge facing to the top of the programmer board.

Im in PCB3 mode with the correct chip type selected as DEVICE.

I have set the jumper settings the same as the picture (BUT, the picture DIP switches are reversed.. mine are the other way round!!)

I have tried BOTH ways and neither produces a chip that has been written correctly.

I wrote one chip IM NOT SURE HOW.. and its incorrect.

Sometimes I get an error message "Error at 0x000000 Chip = 0x00 Buffer = 0x4c

When I "read" the chip... its blank!

I'm using Willem Eprom software 0.97ja

Am I doing something wrong???

Reply #1

chaoticjelly

4 Posts

Posted - 09/21/2005 : 20:17:55

Ok I found a post on another website and ive got it to program I think!

I had to set the DIP switches to the "Willem" setting picture.

I had to put jumper over pins 6+7 on the 8 pin block to the left of the DIP switches.

Programmed, verified OK

Does anyone have any tips for programming 16bit 27c4096as those are OTP and I dont want to mess them up!

Reply #2

usb

138 Posts

Posted - 09/27/2005 : 14:35:05

27C4096 need a 16bit EPROM adapter.
The software should stay in PCB3B and no special setting.

The OTP device only can be read since you can not erase it.

Topic

Forum Locked

Printer Friendly

Jump To:

MCUmall EPROM BIOS Chip Burner Forum

Generated in 0.08 sec.

Snitz Forums 2000