MCUmall EPROM BIOS Chip Burner Forum Active Users: / Visits Today:
Highest Active Users:
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Automobile engine ECU, Immo, Air bag chip tunning
 How to read copy protected M27c256b?		  Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

passuff

7 Posts
Posted - 11/11/2010 :  12:53:31  Show Profile
Hello!

I have a 27C256B with a copy protection socket. From what I read in other forums, this eeprom can be read - but its not so easy. If ECU is reading a single adress from EEPROM it switches CS (chipselect) every time. If I want to read with programmer, chipselect is always set tpo on... This is noticed by the little extra IC on the socket and it returns only crap data...
So I need to write a skript for my willem Programmer to switch CS after reading an adress... But I dont know how... someone does?
Reply #1

passuff

7 Posts
Posted - 11/11/2010 :  14:39:22  Show Profile
maybe i was wrong... its not CS its OE output enable.
Is there a way to toggle OE after reading a single address?
Go to Top of Page
Reply #2

ZLM

2945 Posts
Posted - 11/14/2010 :  10:14:49  Show Profile
no. That pin is controlled by software automatically.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000