hi dear mcu staff Thank you for 29lv and 29w series advice for 8/16 adaptor. I buy one and i solved my problem. Now i have intel 28f160c flash and 16 bit tsop 48 adaptor but i have a problem at erase and writing. When i erasing not complate. What can i do about this problem?
I tell you what i do all for your development software. When i select the TE28F160C3T id is 8988C3. I can read data from flash (true or false data i dont know). When i select erase the vpp led some times doing nothing sometimes intervally working and when erasing %100 the cancel button make passive and after 5 - 10 minutes there is a warning like a dont support or need erasing this chip. And than i push read button some places seem as a @@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ .
When i connect A19 wire and push erase button it erase to %12-13 and finish. I push read button with a19 cable top informations was deleted but some place has a information (The chip isnt blank.) After this operation i disconnect a19 wire and read the chip , te chip is blank :)
After than i select any one of the 2mb dumpfiles it didnt write , again push write button dont write , again again when the process starting at %1 or %4 or %13 (it can different result) there is an error and than again write without erasing it write at %50 and there is an error. The last stop is this point.
After %50 writing when i read the chip top and middle information true bu some times different and bottom information certainly false.
If you have a question about this let me know. I want to helping you.
intel TE28F160C3BD70 problem
Posted - 01/19/2009 : 03:25:49
